WIRELESS FAST CHARGING PAD USERMANUAL Supplied Accessories:
FCC ID:2BAZE-JF2117S REF : JF2117S Input5-9VDC, 13W OutputMax. 10W limits set radiation exposure for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. forth Features:
Works with compatible mobile phones IK08 shock resistance Strong magnets on the rear allow for easy mounting on magnetic surfaces as well as built-
in screw holes for permanent mounting Specifications:
Material:
Ultra tough nylon, Aluminium,Rubber , PC&
TPE If charging by wireless pad:
Charging time: Approx 3.0-8.0 hours depending on battery pack - the environmental temperature will affect the charging and discharging period of the battery Operating temperature:
-5C to +30C Disposal and environmental protection Do not dispose of charging pad with domestic waste Please check with local recycling plants for the best way to recycle This charging pad contains substances that may be harmful to the environment and humans if disposed of inappropriately FCC Warning This device complies with Part 18 of the FCC Rules. Refer to Part 18.213(c) and KDB 784748 Annex A section A.5:
Max. Electric Field Emissions: 6.06V/m Max. Magnetic Field Emissions: 0.54A/m The maintenance of the system is the responsibility of the manufacturer. To prevent interference, the product should be as far away from devices operating at the same frequency as possible. RF exposure considerations This equipment complies with the FCC RF Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1Reorient or relocate the receiving antenna. 2Increase the separation between the equipment and receiver. 3Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4Consult the dealer or an experienced radio/
TV technician for help. MPE caution To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons the antenna of this device and persons during device operation. To ensurecompliance, operations at closer than this distance is not recommended. Made in China JF2117S WIRELESS FAST CHARGING PAD USERMANUAL Ningbo Weijia Electronics Technology Co., Ltd. Made in China JF2117S WIRELESS FAST CHARGING PAD USERMANUAL A C E G F How to use the lamp ?
B D A: Indicator light B: Magnet C: Charge coil D: Mobile phone support E: TYPE-C F: Magnet G: hanging hole 1 Wireless fast charging pads can be sucked onto iron plates 2 Wireless series lights can be charged 3 Support to charge your cell phones(induction charging allowed). Ningbo Weijia Electronics Technology Co., Ltd. Made in China JF2117S